EXPERIMENT NO. 7C

ENZYME IMMOBILIZATION PROTOCOL

ENTRAPMENT IN GELATIN GEL

Prepared by
Nam Sun Wang
Department of Chemical & Biomolecular Engineering
University of Maryland
College Park, MD 20742-2111
ENCH485


Table of Contents


Method

Since this process is quite familiar to all of us who have ever made Jell-O, there is really no need to elaborate. The only difference is that the gel is hardened to provide structural strength.


List of Reagents and Instruments

A. Equipment

B. Reagents


Procedures

  1. Dissolve 10 g gelatin in 100 ml of water to prepare a 10% (wt.) aqueous solution. Heating the solution gently to facilitate the dissolution process.
  2. Adjust the temperature of the gelatin solution to 35-40ºC. The temperature is kept relatively high so that the gelatin solution is not too viscous, but not so high as to cause enzyme denaturation.
  3. Add approximately 0.015 g of the enzyme powder (or an equivalent of concentrated enzyme solution) to 10 ml of the gelatin solution.
  4. Add 2 ml of the Hardening Solution to the above enzyme solution.
  5. Pour the solution into a mold or a small beaker. Freeze at -28ºC for 4 hours to facilitate the gel formation. If this temperature is not readily available, a regular freezer will also suffice for the purpose of demonstrating the technique.
  6. When the gel is set, warm the gel to room temperature simply by leaving it on a lab bench.
  7. Cut the gel into small cubes of approximately 3mm per side.
  8. Gently wash the gel liberally with deionized water.


Discussions

The gel may be liquefied by raising the temperature; however, this may also inactivate many heat labile enzymes.


References

  1. E. de Alteriis, P. Parascandola, S. Salvadore, and V. Sardi, Enzyme immobilization within insolubilized gelatin, J. Chem. Tech. Biotechnol., 35B, 60, 1985.


Return to Prof. Nam Sun Wang's Home Page
Return to Biochemical Engineering Laboratory (ENCH485)

Enzyme Entrapment in Gelatin Gel
Forward comments to:
Nam Sun Wang
Department of Chemical & Biomolecular Engineering
University of Maryland
College Park, MD 20742-2111
301-405-1910 (voice)
301-314-9126 (FAX)
e-mail: nsw@umd.edu